3.5RL V6-3474cc 3.5L (2001)
Trunk / Liftgate Lock: Service and Repair
Trunk Pass-Through Cover Key Cylinder Replacement
NOTE:
-
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
-
Take care not to scratch the cover.
1. Using a flat-tip screwdriver, pry the rear seat handle up at either hook portion on forward side of the trunk pass through cover. Then slide the
handle half-way up.
2. From trunk compartment side of the cover, using a small screwdriver, press the inside hook down through the access hole.
3. While pressing the hook, pry the trunk handle up with a flat-tip screwdriver.
4. Remove the trunk handle and rear seat handle together at the same time.
5. Remove the retainer clip, then remove the trunk pass-through cover key cylinder from the cover.
6. Install the key cylinder in the reverse order of removal, and note these items:
-
Put the two handles together before installing them on the trunk pass-through cover.