3.5RL V6-3474cc 3.5L (2001)
15. Drying top coat
WARNING: Body parts being dried with an industrial dryer can get hot enough to cause injury. Do not touch parts being dried.
-
Before force drying, let it air dry for 5-10 minutes.
-
Force dry the sprayed surface under the infrared lamps for 0-90 minutes.
-
Keep the drying temperature between 140 degrees F (60 degrees C) and 158 degrees F (70 degrees C).
NOTE: Take care not to let the heat deform the part during the drying process.
16. Polishing and Buffing
-
Let the paint dry gradually, then polish the surface carefully using a polishing compound and sponge buff.
-
To remove lint or dirt, wet sand the surface with #2000 or finer paper first, then polish with compound.
NOTE: Polish all roughness caused by sanding thoroughly. To do this, first polish with very fine compound, then with ultra fine compound.
-
After polishing, remove the masking paper and tape and wash the entire vehicle thoroughly.