3.5RL V6-3474cc 3.5L (2001)
-
Air blow the entire surface, then degrease with a wax and grease remover (for USA usage-DuPont 38125 Enamel Reducer).
-
Use the following materials:
-
Spies Hecker Silicon Remover (Herberts)
-
Standox Silicon Remover (Herberts)
-
For shading or spot painting, polish the area with a polishing compound. Sand with a #2000 paper to give a better bonding surface for the
subsequent paint.
19. Masking
-
Remove all existing masking papers, then mask with new papers.
-
Use a heat-resistant masking tape (SCOTCH TAPE) where tape is attached directly to the body.
-
Use brown paper or masking roll paper to cover.
NOTE:
-
Mask the area surrounding the damage sufficiently to prevent overspray. It is also a good practice to use a vinyl cover to protect other areas.
-
Protect resin parts with aluminum foil under the brown paper or masking paper to prevent damage to due to heat during baking.
20. Application of Top Coat Spraying/drying
-
Prior to putting the car in the painting booth, thoroughly clean the interior and spray water over the floor. Be careful about blowing dust and
dirt.
WARNING:
-
Do not use high air pressure; use only an approved, 210kPa (2.1 kgf/sq.cm, 30 psi) air nozzle.
-
Wear goggles or safety glasses to prevent eye injury.
-
Air dry and degrease the surface before spraying the paint. Also clean the surface with a tack cloth.
WARNING:
-
Ventilate when spraying paint. Most paint contains substances that are harmful if inhaled or swallowed. Read the paint label before
opening paint container.
-
Avoid contact with skin. Wear an approved respirator, gloves, eye protection and appropriate clothing when painting.
-
Paint is flammable. Store in a safe place, and keep it away from sparks, flames or cigarettes.
-
Spray color-matched top coat over the prepared surface. Apply 2-3 coats in two directions until the intermediate coat 2 is fully covered.
NOTE: For application of the top coat, refer to Step "16-Application of Intermediate Coat 2."
Pearl color: Pearl enamel + clear coat
Metallic color: Metallic enamel + clear coat
NOTE: With body color are NH-592P and G-79P, spray the scratch resistant clear coat.
-
Use the following materials:
Use materials above or equivalents.