3.5RL V6-3474cc 3.5L (2001)
1. Install the VSA modulator-control unit, then tighten the two 8 mm nuts.
2. Align the connecting surfaces of the VSA control unit 42P connector.
3. Push the locking lever of the VSA control unit 42P connector down until you hear a click.
4. Connect the pressure sensor 3P connector.
5. Connect the six brake lines.
6. Do the steering angle sensor neutral memorization procedure.
7. Bleed the precharge brake line.
8. Bleed the brake system, starting with the front wheels.
9. Start the engine, and check that the ABS and VSA indicators go off.
10. Test-drive the vehicle, and check that the ABS and VSA indicators do not come on.
