3.5RL V6-3474cc 3.5L (2001)
3. Remove the snap ring B with snap ring pliers, then remove the pulley.
NOTE:
-
Be careful not to damage the pulley and corn pressor during removal/installation.
-
Once the snap ring B is removed, replace it with a new one.
4. Remove the screw from the field coil ground terminal. Remove the snap ring A with snap ring pliers, then remove the field coil.
NOTE:
-
Be careful not to damage the field coil and compressor during removal/installation.
-
Once the snap ring A is removed, replace it with a new one.
5. Install in the reverse order of removal. Make note of the following items.
-
Install the field coil with the wire side facing down (see above).
-
Clean the pulley and compressor sliding surfaces with non-petroleum solvent.
-
Make sure the snap rings are fully seated in the groove.
-
Make sure that the pulley turns smoothly after it's reassembled.