3.5RL V6-3474cc 3.5L (2001)
WARRANTY CLAIM INFORMATION
REPAIR PROCEDURE
1.
Disconnect the harness connector from the brake pedal position switch.
2.
Loosen the locknut at the end of the switch, then unscrew the switch and remove it.
**3. Wipe off any excess oil on or around the brake pedal assembly and linkage with a clean shop towel. Pay particular attention to the brake pedal stop
pad and the threaded hole for the switch.**
4.
Screw the new switch into the base until the switch plunger is fully depressed and the threaded end of the switch lightly contacts the stop pad. Then
unscrew the switch 1/4 turn, and tighten its locknut.