3.5RL V6-3474cc 3.5L (2001)
Headlamp Bulb: Service and Repair
WARNING: A transient high tension (25,000 V) occurs at the bulb sockets of the high intensity discharge (HID) lamps when the combination
light switch is turned ON. It may cause serious electrical shock or electrocution if you do not observe the cautions below.
CAUTION:
-
Never turn on the combination Eight switch before fitting the HID bulbs to their bulb sockets and completing the reassembly of the headlight
assembly.
-
To prevent electrocution, do not service the headlights assembly in wet conditions, such as rain or snow, near a sprinkler system, or when your
hands are wet.
-
Do not touch the surface of the HID bulbs with your bare hands and do not stain it with any oils and fats.
-
Do not disassemble the inverter unit and the igniter unit.
-
Do not turn on the HID bulb by using a power source other than the battery mounted on your vehicle.
1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
2. Turn the combination light switch OFF.
3. Disconnect the battery negative cable, then disconnect the positive cable.
4. Remove the Torx bolt (A) using a Torx T20 bit.
5. Turn the cover (B) 45 ° counterclockwise to remove it from the headlight assembly.
6. Turn the socket 45 ° counterclockwise to remove it from the bulb.
