3.5RL V6-3474cc 3.5L (2001)
Information Bus: Reading and Clearing Diagnostic Trouble Codes
Self-Diagnosis Function (Mode 1)
-
One second after you go into self-diagnosis function mode 1, the function starts to indicate the diagnosis trouble code (DTC), and repeats the
DTC every three seconds.
-
From mode 1, disconnect the SCS service connector for five to ten seconds, then reconnect the SCS service connector, and the function goes from
mode 1 to mode 2.
NOTE: If no DTCs are indicated, but you know the system is abnormal, check these items:
-
If the light does not come on and the buzzer does not beep, check the continuity between the BLK wire of the multiplex control inspection
connector and body ground.
-
If either the light or the beep indicates the DTC(s), check the continuity between the PNK/BLK wire of the multiplex control inspection connector
and multiplex control units (driver's and passenger's).
Diagnostic Trouble Code (DTC) Table
NOTE: The numbers in the table show the troubleshooting sequence.
Communication Line Test
1. Continuity Test
Check for continuity according to the table.
-
If there is continuity, go to step 2.
-
If there is no continuity, check for an open in the wire.
2. Voltage Test
A. Turn the ignition switch ON (II).