3.5RL V6-3474cc 3.5L (2001)
How to Use the Backprobe Sets
Connect the backprobe adapters to the stacking patch cords, and connect the cords to a multimeter. Using the wire insulation as a guide for the contoured
tip of the backprobe adapter, gently slide the tip into the connector from the wire side until it comes in contact with terminal end of the wire.
CAUTION:
-
Puncturing the insulation on a wire can cause poor or intermittent electrical connections.
-
Bring the tester probe into contact with the terminal from the terminal side of wire harness connectors in the engine compartment. For female
connectors, lust touch lightly with the tester probe and do not insert the probe.
Powertrain Control Module (PCM) Reset Procedure
NOTE: The PCM memory setting is needed after resetting the PCM.
Either of the following actions will reset the PCM.
-
Use the OBD II scan tool or Honda PGM Tester to clear the PCM's memory.
NOTE: See the OBD II scan tool or Honda PGM Tester user's manuals for specific operating instructions.