3.5RL V6-3474cc 3.5L (2001)
Air Bag: Service and Repair
Driver Side
Driver's Airbag Replacement
WARNING: Store a removed airbag with the pad surface up. If the airbag is improperly stored face down, accidental deployment could propel
the unit with enough force to cause serious injury.
CAUTION:
-
Do not install used SRS parts from another vehicle. When repairing, use only new SRS parts.
-
Carefully inspect the airbag before you install it. Do not install an airbag that shows signs of being dropped or improperly handled, such as dents,
cracks or deformation.
-
Always disconnect the airbag connector(s) when the harness is disconnected.
-
Do not disassemble or tamper with the airbag.
1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
2. Disconnect the battery negative cable, then disconnect the positive cable from the battery, and wait at least 3 minutes.
3. Disconnect the airbag connector(s):
Driver's Airbag:
-
Remove the access panel from the steering wheel, then disconnect the 2P connector between the driver's airbag and cable reel.
Front Passenger's Airbag:
-
Remove the glove box.
-
Disconnect the 4P connector between the front passenger's airbag and SRS main harness.
