3.5RL V6-3474cc 3.5L (2001)
5.
Check the clearance between the threaded end of the switch and the stop pad while you press lightly on the brake pedal with your hand to remove
pedal free play. The clearance between the threaded end and the stop pad should be 0.3 mm (0.01 in.).
6.
Check the brake pedal free play by lightly pushing the pedal with your hand. The free play should be 0.5 to 2.0 mm (0.02 to 0.08 in.).
NOTE:
Incorrect free play may cause the brakes to drag.
^
If the free play is OK, go to step 7.
^
If the free play is out of specification, readjust the brake pedal position switch.
7.
Reconnect the harness connector to the switch.
8.
Check the brake lights. They should come on when you press the brake pedal and go off when you release it.
9.
Start the engine. Make sure the MIL, the VSA indicator, and the ABS indicator go off after a few seconds. If they don't, clear the DTC(s) (see
section 19 of the appropriate service manual).
10.
Center-punch a completion mark above the first character of the engine compartment VIN.
