3.5RL V6-3474cc 3.5L (2001)
11. Remove the two flange bolts, then remove the valve body unit from the gearbox.
12. Drill a 3 mm (0.12 inch) diameter hole approximately 2.5 - 3.0 mm (0.10 - 0.12 inch) in depth in the staked point on the cylinder.
NOTE:
-
Do not allow metal shavings to enter the cylinder.
-
After removing the cylinder end, remove any burrs at the stake point.
13. Install the special tool on the gearbox housing.