3.5RL V6-3474cc 3.5L (2001)
4. Disconnect the connector, detach the harness clip, then remove the windshield wiper linkage assembly.
5. Separate the windshield wiper linkage and windshield wiper motor.
NOTE: When installing, align the alignment marks on the link and windshield wiper linkage.
6. Installation is the reverse of the removal procedure.
NOTE:
-
Make sure the connector is connected properly.
-
If necessary, replace any damaged clips.
-
Install the windshield wiper arms properly as described
-
Check the windshield wiper motor operation.
-
Grease the moving parts.