CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
Driver's Seat Base Assembly (includes new control unit and recline motor):
P/N 81510-SS8-A02
Driver's Seat Base Subassembly (excludes control unit and recline motor):
P/N 81510-SS8-999
REPAIR PROCEDURE A [NEW]
Up to VIN 19UYA22...VL004392
1.
Remove the seat track end covers, and remove the four bolts securing the driver's seat.
2.
Tilt back the seat, inspect the white label on the bottom side of the control unit, and record the version number of the control unit (9.0x).
3.
Remove the seat from the vehicle, and set it on a cloth-covered bench.
4.
Remove the seat base assembly referring to the 1997-98 3.0CL Service Manual.
5.
Depending on the control unit version number recorded in step 2, determine if an updated control unit has been installed already. Reassemble the
seat with the appropriate seat base.
^
If equipped with version 9.06, install a new seat base assembly (includes new control unit and recline motor).
^
If equipped with version 9.08, install a new seat base subassembly (reuse the original control unit and recline motor).
6.
Set the seat in the vehicle, and reconnect the connectors.
7.
Reinstall the seat. and torque the seat mounting bolts to 34 N.m (25 lb-ft). Reinstall the seal track end covers.
8.
Move the seat to the end of its travel in both forward and reverse directions to set the new control unit.
9.
Position the seat in the middle of its travel. Lift the seat-back release lever, and make sure the seat moves forward. Then make sure it moves back
into its original position when you return the seat-back to the upright position.
REPAIR PROCEDURE B [NEW]
From VIN 19UYA22...VL004393 thru
VIN 19UYA22... WL006011
1.
Determine which group of symptoms the problem falls in.
