CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
Brake Bleeding: Service and Repair
Conventional Brake System
CAUTION:
-
Use only clean Honda Genuine DOT 3 Heavy Duty brake fluid or an equivalent DOT 3 or 4 brake fluid.
-
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
NOTE: The reservoir on the master cylinder must be at the MAX (upper) level mark at the start of bleeding procedure and checked after bleeding each
brake caliper. Add clean new fluid from a sealed container as required.
Reservoir MAX Level
1. Make sure the brake fluid level in the reservoir is at the MAX (upper) level line.
2. Have someone slowly pump the brake pedal several times, then apply steady pressure.
Front Brake Bleeder Valve
Rear Disc Brake Bleeder Valve
3. Connect a hose to the brake bleed screw at the right rear wheel and place the open end in a container to collect the expelled fluid.
4
Loosen the bleed screw to allow air to escape from the system. When the brake pedal reaches the end of it's stroke, hold the pedal down and
