CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
Brake Lamp Switch Adjustment
- Screw in the brake switch until its plunger is fully depressed (threaded end touching the pad on the pedal arm). Then back off the switch 1/4 turn
to make 0.3 mm (0.01 in) of clearance between the threaded end and pad. Tighten the locknut firmly. Connect the brake switch connector.
CAUTION: Make sure that the brake lights go off when the pedal is released.
- Check the brake pedal free play as described below.
PEDAL FREE PLAY
- With the engine off, inspect the play on the pedal pad by pushing the pedal by hand.
Free Play: 1-5 mm (1/16-13/64 in)
- If the pedal free play is out of specification, adjust the brake switch.
CAUTION: If the pedal free play is insufficient, it may result in brake drag.