CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
Crankshaft: Testing and Inspection
Crankshaft Inspection
INSPECTION
-
Clean the crankshaft oil passages with pipe cleaners or a suitable brush.
-
Check the keyway and threads.
-
Measure runout on all main journals to make sure the crank is not bent.
-
The difference between measurements on each journal must not be more than the service limit.
Crankshaft Total Indicated Runout:
Standard (New): 0.03 mm (0.001 in.) max.
Service Limit: 0.04 mm (0.002 in.)
Out-of-Round and Taper
-
Measure out-of-round at the middle of each rod and main journal in two places.
-
The difference between measurements on each journal must not be more than the service limit.
Journal Out-of-Round:
Standard (New): 0.005 mm (0.0002 in.) max.
Service Limit: 0.006 mm (0.0002 in.)
-
Measure taper at the edge of each rod and main journal.
-
The difference between measurements on each journal must not be more than the service limit.