CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
Oil Filter: Service and Repair
REPLACEMENT
WARNING:
-
After the engine has been run, the exhaust pipe will be hot; be careful when working around the exhaust pipe.
-
Be careful when loosening the drain bolt while the engine is hot. Burns can result because the oil temperature is very high.
1. Remove the oil filter with the special oil filter wrench.
2. Inspect the threads and rubber seal on the new filter. Wipe off the seat on the engine block, then apply a light coat of oil to the filter rubber seal.
NOTE: Use only filters with a built-in bypass system.
3. Install the oil filter by hand.
4. After the rubber seal seats, tighten the oil filter clockwise with the special tool.
Tighten: 7/8 turn clockwise.
Torque: 22 Nm (2.2 kgf/m, 16 ft.lbs.)
