CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
Brake Fluid: Service and Repair
CAUTION: Do not loosen the relief plug on the accumulator.
NOTE: Brake fluid replacement procedure explained in this article is for the brake fluid in the modulator unit (that is, the brake fluid in the
high-pressure passage and in the reservoir). Fluid replacement procedures for the rest of the brake system are incorporated into the brake bleeding
procedures for the basic brake hydraulic system.
1. Start the engine and let it idle for a minute. Stop the engine.
2. Check the brake fluid level in the reservoir. It should be below the MAX (upper) level line.
3. Use the steps below to drain the rest of the brake fluid from the modulator unit.
NOTE: Approximately 35 - 45 ml (1 1/6 - 1 1/2 fl.oz) of the fluid is drained at each try.
Modulator Unit Location
A) Attach a wrench to the maintenance bleeder.
B) Connect a rubber tube of the appropriate diameter to the maintenance bleeder, and set the other end of the rubber tube in a suitable container.
C) While holding the rubber tube with your hand, slowly loosen the maintenance bleeder 1/8 to 1/4 turn to collect the brake fluid in the container.
CAUTION: Do not loosen the maintenance bleeder too much. The high-pressure brake fluid can burst out.
D) Start the engine and let it idle for a minute. Stop the engine.
E) Check the brake fluid level in the reservoir. It should be below the MAX (upper) level line.
F) Tighten the maintenance bleeder.
4. Remove the cap, and refill the reservoir to the MAX (upper) level with fresh brake fluid.
NOTE: Pour the brake fluid slowly so that it does not foam, and wait for a few minutes.
