CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
17. Remove the cotter pin from the lower arm ball joint castle nut, and remove the nut.
18. Install a 12 mm hex nut on the ball joint. Be sure that the hex nut is flush with the ball joint pin end, or the threaded section of the ball joint pin
might be damaged by the ball joint remover.
19. Use the special tool as shown previously to separate the lower ball joint and lower arm.
NOTE: If necessary, apply penetrating type lubricant to loosen the ball joint.
20. Remove the cotter pin from the upper ball joint castle nut, and remove the nut.
21. Install a 10 mm hex nut on the ball joint. Be sure that the hex nut is flush with the ball joint pin end, or the threaded section of the ball joint pin
might be damaged by the ball joint remover.
22. Use the special tool as shown previously 10 to separate the upper ball joint and knuckle.
NOTE: If necessary, apply penetrating type lubricant to loosen the ball joint.
