CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
Ball Joint: Service and Repair
Ball Joint Replacement
Ball Joint Replacement
TOOL REQUIRED
-
07HAF-SF10110 Ball Joint Remover/Installer
-
07HAF-SF10130 Ball Joint Remover Base
-
07HAF-SF10120 Ball Joint Installer Base
-
07GAG-SD40700 Ball Joint Boot Clip Guide
1. Remove the knuckle, then remove the hub unit from the knuckle.
2. Remove the boot by prying the set ring off.
3. Check the boot for deterioration and damage, and replace it if necessary.
4. Install the special tools on the ball joint, and tighten the castle nut.
5. Position the special tools over the ball joint as shown, then set the assembly in a vise. Press the ball joint out of the knuckle.
6. Place the ball joint in position by hand.
7. Install the special tools over the ball joint as shown, then press the ball joint in.
8. Install the ball joint boot and set ring using the special tool.
9. Install the knuckle in the reverse order of removal, and pay particular attention to the following items:
-
Be careful not to damage the ball joint boots when installing the knuckle.
-
Torque all mounting hardware to the specified torque values.
-
Torque the castle nuts to the lower torque specifications, then tighten them only far enough to align the slot with the pin hole. Do not align the
castle nut by loosening.
-
Install new cotter pins on the castle nuts after torquing.
-
Avoid twisting the sensor wires when installing the wheel sensor.
