CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
22.
Remove the wooden block, then install the axle into the hub. To avoid damaging the ABS sensor harness, do not let the knuckle hang by its
weight.
*23. Distribute the grease inside the ball joint by moving the ball joint stud left-and-right and back-and-forth about ten times. Then rotate the stud in a
circle several times.*
24.
Install the lower control arm onto the ball joint.
25.
Install and torque the ball joint castle nut. Install the new cotter pin.
26.
Apply oil to the threads and flange of the new spindle nut. Install the new spindle nut; torque it to 245 Nm (181 lb-ft).
27.
Stake the spindle nut.
28.
Repeat steps 2 through 27 on the other side.
29.
Reinstall the front wheels. Tighten the wheel nuts to 108 Nm (80 lb-ft).
30.
Lower the vehicle.
31.
Center-punch a completion mark above the third character of the engine compartment VIN.
