CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
10. Remove the 6 mm brake disc retaining screws.
11. Screw two 8 x 1.25 mm bolts into the disc to push it away from the hub.
NOTE: Turn each bolt two turns at a time to prevent cocking the disc excessively.
12. Remove the brake disc.
13. Remove the hub bearing unit from the knuckle. Refer to Steering and Suspension.
NOTE:
-
Wash the bearing and spindle thoroughly in high flash point solvent before reassembly.
-
Before installing the brake disc, clean the mating surfaces of the rear hub and brake disc.
14. Install in reverse order of removal. Tighten the new spindle nut to the specified torque, then stake the spindle nut shoulder against the spindle.
