CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
Bell Housing: Service and Repair
Secondary Shaft Bearing
TOOL REQUIRED
-
07746-0010400 Driver Attachment, 52x55 mm
-
07749-0010000 Handle Driver
1. Remove the secondary shaft bearing by heating the torque converter housing to 212°F (100°C) with a heat gun, then tap the housing until the
bearing falls out.
CAUTION: Do not heat the case in excess of 212°F (100°C).
2. Install the ATF guide plate.
3. Install the new bearing into the housing using the special tools as shown.