CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
Shift Cable: Adjustments
CAUTION: SRS components are located in this area. Review the SRS component locations, precautions, and procedures before performing repairs or
service.
1. Remove the front console.
2. Shift to N position, then remove the lock pin from the adjuster.
3. Check that the hole in the adjuster is perfectly aligned with the hole in the shift cable.
NOTE: There are two holes in the adjuster. They are positioned 90° apart to allow cable adjustments in 1/4 turn increments.
4. If the hole is not perfectly aligned, loosen the locknut on the adjuster, and adjust as required.
5. Tighten the locknut.
6. Install the lock pin on the adjuster. If you feel the lock pin binding as you reinstall it, the cable is still out of adjustment and must be readjusted.
7. Make sure the lock pin is seated securely in the adjuster.
NOTE: Replace the lock pin if it does not snap over the adjuster securely.
8. Move the shift lever to each gear, and verify that the A/T gear position indicator follows the A/T gear position switch.
9. Start the engine, and check the shift lever in all gears. If any gear does not work properly, refer to troubleshooting.
10. Insert the ignition key into the key cylinder on the A/T gear position indicator panel, and verify that the shift lock lever is released.
