CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
Wheel Bearing: Service and Repair
Rear
NOTE:
-
Use only genuine Acura wheel weights for aluminum wheels. Non-genuine wheel weights may corrode and damage the aluminum wheels.
-
For aluminum wheels, remove the center cap by prying it out with a flat screwdriver. Use a rag at the point you are going to pry because aluminum
alloy wheels can be easily damaged. Avoid damage to the cap by not allowing it to fall during removal.
-
Before installing the brake disc, clean the mating surfaces of the rear hub and brake disc.
-
Before installing the wheel, clean the mating surfaces of the brake disc and wheel.
1. Loosen the wheel nuts slightly.
2. Raise the rear of car, and support it with safety stands in the proper locations.
3. Remove the wheel nuts and rear wheel.
4. Pull the parking brake lever up.
5. Remove the hub cap.
6. Raise the locking tab on the spindle nut, then remove the nut.
7. Release the parking brake lever.
8. Remove the brake hose mounting bolts.
9. Remove the caliper bracket mounting bolts and hang the caliper to one side.
CAUTION: To prevent accidental damage to the caliper or brake hose, use a short piece of wire to hang the caliper from the undercarriage.
