CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
Flywheel: Testing and Inspection
1. Inspect the ring gear teeth for wear and damage.
2. Inspect the clutch disc mating surface on the flywheel for wear, cracks, and burning.
3. Measure the flywheel runout using a dial indicator through at least two full turns. Push against the flywheel each time you turn it to take up the
crankshaft thrust washer clearance.
NOTE: The runout can be measured with the engine installed.
-
Standard (New): 0.05 mm (0.002 inch) max.
-
Service Limit: 0.15 mm (0.006 inch)
-
If the runout is more than the service limit, replace the flywheel and recheck the runout.
4. Install the special tool as shown.
5. Remove the flywheel mounting bolts in a crisscross pattern in several steps as shown, then remove the flywheel .
6. Align the hole in the flywheel with the crankshaft dowel pin, and install the flywheel. Install the mounting bolts finger-tight.
7. Install the special tool, then torque the flywheel mounting bolts in a crisscross pattern in several steps.
