CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
4. Remove the friction damper from the spacer using a press and a socket as shown.
INSPECTION
1. Inspect the gear surface and bearing surface for wear and damage, then measure the countershaft at points A, B. and C.
-
Standard:
-
A: 38.000 - 38.015 mm (1.4961 - 1.4967 inch)
-
B: 39.984 - 40.000 mm (1.5742 - 1.5748 inch)
-
C: 24.987 - 25.000 mm (0.9837 - 0.9843 inch)
-
Service Limit:
-
A: 37.950 mm (1.4941 inch)
-
B: 39.930 mm (1.5720 inch)
-
C: 24.940 mm (0.9819 inch)
-
If any part of the countershaft is less than the service limit, replace it with a new one.
2. Inspect for runout.
-
Standard: 0.02 mm (0.0008 inch) max.
-
Service Limit: 0.05 mm (0.002 inch)
NOTE: Support the countershaft at both ends as shown.
If the runout exceeds the service limit, replace the countershaft with a new one.
