CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
3. In the same manner as above, support the 3rd gear on steel blocks, and press the mainshaft out of the 3rd/4th synchro hub, as shown.
INSPECTION
1. Inspect the gear surface and bearing surface for wear and damage, then measure the mainshaft at points A, B. and C.
-
Standard:
-
A (Ball bearing surface): 27.987 - 28.000 mm (1.1018 - 1.1024 inch)
-
B (Needle bearing surface): 37.984 - 38.000 mm (1.4954 - 1.4961 inch)
-
C (Ball bearing surface): 27.977 - 27.990 mm (1.1015 - 1.1020 inch)
-
Service Limit:
-
A: 27.940 mm (1.1000 inch)
-
B: 37.930 mm (1.4933 inch)
-
If any part of the mainshaft is less than the service limit, replace it with a new one.
2. Inspect for runout.
-
Standard: 0.02 mm (0.0008 inch) max.
-
Service Limit: 0.05 mm (0.002 inch)
NOTE: Support the mainshaft at both ends as shown.
If the runout is more than the service limit, replace the mainshaft with a new one.
