CL L4-2254cc 2.3L SOHC (VTEC) MFI (1998)
_mfi/Page-3647004.png)
2. Remove and discard the ball bearing using the special tool and a press as shown.
3. Install the new ball bearing using the special tool and a press as shown.
ASSEMBLY
1. Coat the lip of the new oil seal with steering grease.
2. Install the new oil seal in the pump housing by hand, then install the pump seal spacer.
NOTE: Insert the oil seal with its grooved side facing in.
3. Install the pump drive shaft assembly with the special tool.
4. Install the 38 mm circlip with its tapered side facing out.
