CL L4-2254cc 2.3L SOHC (VTEC) MFI (1998)
9. Close the shut-off valve, then close the pressure control valve gradually until the pressure gauge needle is stable. Read the pressure.
10. Immediately open the shut-off valve fully.
CAUTION: Do not keep the shut-off valve closed more then 5 seconds or the pump could be damaged by over-heating.
-
If the pump is in good condition, the gauge should read at least 6,400 - 7,400 kPa (924- 1,067 psi).
-
A low reading means pump output is too low for full assist. Repair or replace the pump.