CL L4-2254cc 23L SOHC (VTEC) MFI Steering Gear Removal
11. Remove the two flange bolts, then remove the valve body unit from the gearbox. )
12. Drill a 3 mm (0.12 inch) diameter hole approximately 2.5 - 3.0 mm (0.10 - 0.12 inch) in depth in the staked-point on the cylinder.
NOTE:
-
Do not allow metal shavings to enter the gearbox housing.
-
After removing the cylinder end, remove any burrs at the stake point.
13. Install a puller yoke to the gearbox housing. Clamp the puller yoke in a vise with son jaws as shown, then loosen and remove the cylinder end.
CAUTION: Do not clamp the cylinder.
14. Remove the gearbox housing from the vise, and set it the in a press so the gearbox points upward.