CL L4-2254cc 2.3L SOHC (VTEC) MFI (1998)
CAUTION: Be careful not to damage the edges of the sleeve grooves and outer surface when removing the seal rings.
29. Using a cutter or an equivalent tool, cut the valve seal ring and O-ring at the groove the pinion shaft. Remove the valve seal ring and O-ring.
CAUTION: Be careful not to damage the edges of the pinion shaft groove and outer surface when removing the valve seal ring and O-ring.
30. Remove the valve oil seal and backup ring from the pinion shaft.
NOTE:
-
Inspect the ball bearing by rotating the outer race slowly. If there is any excessive play, replace the pinion shaft and sleeve as an assembly.
-
The pinion shaft and sleeve are a precise fit; do not intermix old and new pinion shafts and sleeves.
31. Press the valve oil seal and roller bearing out of the valve housing using a hydraulic press and special tool shown below.