CL L4-2254cc 2.3L SOHC (VTEC) MFI (1998)
_mfi/Page-3709012.png)
65. Install the boots in the rack end with the tube clamps.
NOTE:
-
Install the boots with the rack in the straight ahead position fright and led tie-rods are equal in length).
-
To ease boot installation, apply a thin coat of the grease to both ends of the boot.
66. Adjust the air hose fitting position of the boots by turning it as shown below.
67. Connect the air tube between the right and left boot, then install the clips on the cylinder line B as shown.