CL V6-3.0L SOHC (VTEC) (1999)
4. Remove the screw from the field Coil ground terminal. Remove the snap ring A with snap ring pliers, then remove the field Coil.
NOTE:
-
Be Careful not to damage the field Coil and compressor during removal/installation.
-
Once the snap ring A is removed, replace it with a new one.
5. Install in the reverse order of removal. Make note of the following items.
-
Install the field coil with the wire side facing down (see above).
-
Clear the pulley and compressor sliding surfaces with non-petroleum solvent.
-
Make sure the snap rings are in the grooves properly.
-
Make sure that the pulley turns smoothly after it's reassembled.