CL V6-3.0L SOHC (VTEC) (1999)
/Page-2261002.png)
6.
Use an 8 mm drill bit and carburetor cleaner to clean the EGR port in the manifold. Turn the drill bit only by hand. Do not use a power drill. After
you clean the EGR port, use carburetor cleaner to thoroughly clean the inside of the manifold.
7.
Check the EGR port in the front injector base on the engine for blockage. If you see any blockage, clean the EGR port.
8.
Install the intake manifold cover bracket(s) you saved in step 4 on the new intake manifold chamber.
9.
Slip the new 12 mm diameter hose clamp onto the new PCV hose. Connect the hose to the port on the bottom of the manifold chamber. Secure it
with the clamp. Position the clamp with its tangs facing toward the manifold chamber.
10.
Install the manifold chamber onto the manifold with the gaskets, brace, and mounting hardware you saved in step 4. Torque the bolts and nuts to
12 Nm (8.7 lb-ft).
11.
Connect the other end of the PCV hose to the PCV valve with the hose clamp you saved in step 5.
12.
Push the PCV cap onto the intake manifold port. Secure it with the 15.5 mm diameter hose clamp.
