CL V6-3.0L SOHC (VTEC) (1999)
NOTE: Be sure to pull on the sleeve and not on the connector half.
Connecting
1. Hold the pawl-side connector half, and press on the back of the sleeve-side connector half in the direction shown. As the two connector halves are
pressed together, the sleeve is pushed back by the pawl.
2. When the connector halves are completely connected, the pawl is released, and the spring-loaded sleeve locks the connector.
Checking Voltage
Backprobing Spring-loaded Lock connectors
When checking voltage or resistance on this type of connector the first time, it is necessary to remove the retainer to insert tester probes from the wire
side.
NOTE: It is not necessary to reinstall the removed retainer; the terminals will stay locked in the connector housing.