CL V6-3.0L SOHC (VTEC) (1999)
9. Separate the tie-rod ball joint and knuckle using the special tool.
10. Remove the left tie-rod end, then slide the rack all the way to the right.
11. Remove the center beam.
12. Disconnect the heated oxygen sensor (H02S) connector.
13. Remove exhaust pipe A.
NOTE: Always replace the gaskets with new ones.
14. Disconnect the two lines from the valve body unit on the steering gearbox.
CAUTION: After disconnecting the lines, plug or seal the lines with a piece of tape or equivalent to prevent foreign materials from entering the
valve body unit.