CL V6-3.0L SOHC (VTEC) (1999)
Front Door Window Regulator: Service and Repair
Glass/Regulator Replacement
1. Remove:
^
Door panel
^
Plastic cover
2. Lower the glass fully, then peel off the channel guide cover. Remove the screws, then remove the rear channel guide by pulling it upward.
NOTE: When installing the channel guide cover, apply the double-faced adhesive tape to it.
3. Carefully move the glass until you can see the bolts, then remove them.
NOTE: Take care not to drop the glass inside the door.
4. Carefully pull the glass out through the window slot.
NOTE:
^
Take care not to drop the glass inside the deer.
^
Check the guide pin for damage, and replace it if necessary.
^
Scribe a line around the guide pin to show the original location.