CL TYPE S V6-3.2L SOHC (2001)
12. From Mode 1, disconnect the special tool from the multiplex control inspection connector for about ten seconds, then reconnect it. The ignition
key light should come on and the beeper should beep for 2 seconds, then blink and beep twice more at 0.2 second intervals. This means the system
has gone from Model to Mode 2.
NOTE: To cancel mode 2, disconnect the SCS service connector from the multiplex control inspection connector for more than 10 seconds or
turn the ignition switch OFF.
13. Look in the following tables for the switch most closely related to the problem. While still in Mode 2, operate the switches to test the circuits
between the switches and its control unit. If the circuit is OK, the ignition key light should blink once and the beeper should beep once. If the