CL TYPE S V6-3.2L SOHC (2001)
15.
Use a small, flat-tipped screwdriver to lightly dimple the shield in eight places as shown.
NOTICE
Do not press too hard with the screwdriver when dimpling the shield. The dimples should be deep enough to catch your fingernail on. If the dimples
are too deep, the steering effort will be too high, and the steering column will have to be replaced.
16.
199~01 3.2TL and 2001-02 3.2CL models:
Reinstall the combination switch assembly, and secure it with the three original screws. Reconnect the light switch 14P connector, the steering
angle sensor 5P connector (on Type-S models), and both wiper/washer switch 8P connectors.
2002-03 3.2TL and 2003 3.2CL models: Reinstall the combination switch assembly, and secure it with the three original screws. Reconnect the
light switch 14P connector, the steering angle sensor 5P connector (on Type-S models), and the wiper/washer switch 8P connector.
17.
Position the cancel sleeve on the combination switch assembly so that the projections on the sleeve are aligned vertically.
18.
Carefully reinstall the cable reel with the original screws.
19.
1999-01 3.2TL and 2001-02 3.2CL models:
Reconnect the SRS main harness 2P connector and the cable reel 2P connector, and then plug the dashboard wire harness 4P connector and cable
reel 4P connector together.
2002-03 3.2TL and 2003 3.2CL models:
Reconnect the SRS main harness 4P and dashboard wire harness 4P connectors to the cable reel 4P connectors.
20.
Reinstall the upper and lower steering column covers with the original screws.
21.
If needed, center the cable reel by first rotating the reel clockwise until it stops and then rotating it counterclockwise (approximately two and a half
turns) until the arrow mark on the reel label points straight up.
22.
Line up the paint marks, and reinstall the steering wheel. Torque the bolt to 38 N-m (28 lb-ft).
