CL TYPE S V6-3.2L SOHC (2001)
circuit is faulty, there will be no indication.
Does the ignition key light blink and beeper beep?
YES - The circuit is OK. Refer to the test(s) for that individual system.
NO - Go to step 14.
In each table, the control unit is followed by a list of circuits that it can check in Mode 2.
14. Check two or three more circuits listed for that control unit.
Does the ignition key light blink and the beeper beep for each circuit?
YES - The additional circuits are OK. Repair the short or open in the circuit that failed the test in the preceding step.
NO - Multiple failed circuits can mean that the control unit has failed or a power or ground problem, but without triggering a DTC. Test a few
more circuits. If they also fail, test the power and ground inputs to all three control units. If all the input tests are OK, substitute a known-good
control unit, then recheck If the system works properly, the original control unit is faulty; replace it. If there is still a malfunction, substitute a
known-good control unit for the next most likely faulty control unit, then recheck. If the system works properly, that control unit is faulty; replace
it.
