CL TYPE S V6-3.2L SOHC (2001)
-1 Any adhesion or roughness on the top coat should be wet sanded and repaired.
Use #1200~#2000 sandpaper and a crystal block.
-2 Polish all roughness caused by sanding.
NOTE: Clear the top coat surface frequently so you don't damage the clear coat with the polishing particles.
Use a buffing towel, buffing wool, and compound.
-3 Finish by buffing.
NOTE:
-
Do not use a power buffer.
-
Don't polish too much; use light hand pressure.
Use a buffing sponge, fine compound, very fine compound, then ultra fine compound.
-4 After buffing, remove the masking paper and tape, and thoroughly wash the entire vehicle.