CL TYPE S V6-3.2L SOHC (2001)
11. Apply battery power to the B13 terminal and ground the B12 [or B14] terminal.
Does right mirror swing left [or tilt down] ?
YES - Go to step 12.
NO - Check the power mirror actuator. If the mirror is OK, repair the open in the YEL/WHT or LT GRN [BLU/WHT] wires.
12. Apply battery power to the B16 terminal and ground the B15 [or B17] terminal.
Does left mirror swing left [or tilt down] ?
YES - Go to step 13.
NO - Check the power mirror actuator. If the mirror is OK, repair the open in the BLU/GRN or BLU/ORN [BRN] wires.
13. Reconnect the 22P connector B to the passenger's multiplex control unit.
14. Turn the ignition switch ON (II)
15. Check for voltage between the B8 and B22 terminals.
Is there about 5 V?
YES - Go to step 16.
NO - Repair open or short in the RED/BLK wire. If the wire is OK, replace the passenger's multiplex control unit.
16. Check for voltage between the B8 and B19 terminals.