CL TYPE S V6-3.2L SOHC (2001)
Brake Caliper: Service and Repair
Removal and Installation
Replacement
1. Raise the rear of the vehicle, and make sure it is securely supported. Remove the rear wheel.
2. Release the parking brake.
3. Remove the brake hose (A) from the suspension arm by removing the mounting bolt.
4. Remove the flange bolts (B) while holding the pins (C) with a wrench being careful not to damage the pin boot, and remove the caliper (D). Check
the hose and pin boots for damage and deterioration. Thoroughly clean the outside of the caliper to prevent dust and dirt from entering inside.
Support the caliper with a piece of wire so it does not hand from the brake hose.
5. Remove the pad shims (A) and brake pads (B).
6. Remove the pad retainers (A).
7. Clean the caliper thoroughly; remove any rust, and check for grooves and cracks.
8. Check the brake disc for damage and cracks.
9. Install the pad retainers.
