CL TYPE S V6-3.2L SOHC (2001)
10. Apply Molykote M77 grease to the pad side of the shims (A), the back of the pads (B), and other areas indicated by the arrows. Wipe excess
grease off the shim. Contaminated brake discs or pads reduce stopping ability. Keep grease off the discs and pads.
11. Install the brake pads (B) and pad shims on the caliper bracket. Install the pad with the wear indicator (C) on the inside.
If you are reusing the pads, always reinstall the pads in their original positions to prevent a momentary loss of braking efficiency.
12. Push in the piston so the caliper will fit over the pads. Make sure the piston boot is in position to prevent damaging it when installing the caliper.
13. Install the brake caliper (A).
14. Install the flange bolts (B), and torque them to the specified torque. Be careful not to damage the pin boots. Check the hose and pin boots for
damage and deterioration.
15. Install the brake hose (D) onto the suspension arm with the mounting bolt.
16. After installation, check for leaks at hose and line joints and connections, and retighten if necessary.
17. Press the brake pedal several times to make sure the brakes work, then road-test.
NOTE: Engagement of the brake may require a greater pedal stroke immediately after the brake pads have been replaced as a set. Several
applications of the brake pedal will restore the normal pedal stroke.
