CL TYPE S V6-3.2L SOHC (2001)
3.
Check the movement of the float in the reservoir:
^
If the float moves up and down freely, go to step 4.
^
If the float does not move freely, replace the cap and recheck the symptom.
4.
Check that the float does float in brake fluid:
^
If it floats, go to step 5.
^
If it sinks, replace the float and recheck the symptom.
5.
Check for continuity between the terminals on the cap. You should find no continuity when the float is up, and continuity when the float is down.
^
If continuity is correct, go to REPAIR PROCEDURE.
^
If continuity is not correct, replace the cap and recheck the symptom.
REPAIR PROCEDURE
1.
Remove the brake master cylinder cap.
2.
Remove and discard the old filter.
3.
Install the new filter in the master cylinder.
4.
Reinstall the brake master cylinder cap.
5.
Check that the brake system indicator is off.
Disclaimer
