CL TYPE S V6-3.2L SOHC (2001)
20. Remove the two end intake rocker shaft mounting bolts, then install and connect the special tools and an air pressure regulator with a 0 - 100 psi
gauge (A) as shown.
21. Loosen the valve on the regulator, and apply the specified air pressure.
Specified Air Pressure: 440 - 540 kPa (4.5 - 5.5 kgf/cm2, 64 - 78 psi)
NOTE: If the synchronizing pistons A and B do not move after applying air pressure, move the primary or secondary rocker arm up and down
manually.
22. Make sure that the intake primary rocker arm (A) and intake secondary rocker arm (B) are mechanically connected by the piston and that the mid
rocker arm (C) does not move when pushed manually. If any intake mid rocker arm moves independently of the primary and secondary rocker
arms, replace the rocker arms as a set.
23. Remove the tools.
24. Check for smooth operation of each lost motion assembly. Replace the lost motion assembly if it does not move smoothly.
