CL TYPE S V6-3.2L SOHC (2001)
9. Check for continuity between DLC terminal No.15 and PCM terminal A21.
Is there continuity?
YES - Update the PCM if it does not have the latest software, or substitute a known-good PCM, then recheck. If the symptom/indication goes
away with a known-good PCM, replace the original PCM.
NO - Repair open in the wire between DLC terminal No. 15 and the PCM (A21). After repairing the wire, check the DTC with the OBD II scan
tool/Honda PGM Tester, then go to the DTC Troubleshooting Index.
10. Turn the ignition switch OFF.
11. Disconnect PCM connector A (32P). Make sure the OBD II scan tool or Honda PGM Tester is disconnected from the DLC.
12. Turn the ignition switch ON (II).
13. Measure voltage between DLC terminals No.13 and No.15.
Is there 0 V?
YES - Update the PCM if it does not have the latest software, or substitute a known-good PCM, then recheck. If the symptom/indication goes
away with a known-good PCM, replace the original PCM.
NO - Repair short to power in the wire between DLC terminal No.15 and the PCM (A21). After repairing the wire, check the DTC with the OBD
II scan tool/Honda PGM Tester, then go to the DTC Troubleshooting Index.
