CL TYPE S V6-3.2L SOHC (2001)
-
An open in wire between the PSP switch and G201.
11. Turn the ignition switch OFF.
12. Disconnect the PSP switch 2P connector.
13. Turn the ignition switch ON (II).
14. Measure voltage between PCM connector terminals A26 and B20.
Is there battery voltage?
YES - Replace the PSP switch.
NO - Go to step 15.
15. Turn the ignition switch OFF.
16. Disconnect PCM connector A (32P).
17. Check for continuity between body ground and PCM connector terminal A26.
Is there continuity?
YES - Repair short in the wire between the PCM (A26) and the PSP switch.
NO - Substitute a known-good PCM and recheck. If voltage is normal, replace the original PCM.
